|
 Terms of Payment:
T/T
Supply Ability:
100000 Piece/Pieces per Month
Minimum Order:
1 Piece/Pieces
Packaging:
1
Delivery Lead Time:
1 day
1. Use as the telephone line backup in alarm system - Phone lines can easily be cut off during storms, construction work, accidents, or even deliberate tampering by intruders. WT 1010 will checks the status of the telecom line in the alarm system and in case the telecom line become unavailable, the WT 1010 will transmit the alarm using GSM to the alarm receiving center (ARC) or Center Monitoring Station (CMS)
2. Automatically call to 8 pre-program phone numbers while alarming. The WT 1010 also will SMS to 8 programmable cell phone number to notify the user that the PSTN line has been cut off or unavailable
3.Programmable Contact ID - The WT-1010 has built-in alarm inputs that allow the unit to send additional signals (with user programmable Contact-ID event) to the monitoring station. Supported Protocol: Pager message (DTMF no handshake)
4. Three Remote Controlling Outputs - These open collector outputs (that can sink max 300ma per output) can be turned on and off remotely through a SMS. You can use them to pull to ground your inputs. Remote control will be reachable by sending a SMS with a certain command. For example, switch on lighting, air conditional, or switch off generator, sensor using your mobile phone.
5. Three digital input The system has the function to send alert message to the user in the even of input triggered. For example, Zone 4 connected to an electrical door, when there is intruder or electrical door is open illegally, WT 1010 will receive short circuit impulse on Zone 4 and automatically send a signal to the monitoring station and notify the owner. It is possible to enable or disable the function by sending the sms command to the unit
6. In order prevent professional thief tries to disconnect GSM by using GSM Jammer, WT 1010 will transmit the contact ID using telecom line if GSM signal drop immediately and trigger the siren.
7. Auto Test Reporting System - After the programmed reporting time, the WT 1010 will dial the programmable center station number. Once the call is connected, it will transmit the programmable contact-id to the central station and hang up. This function is to make sure that GSM alive daily and able to report to ARC if any emergency.
8. Auto self check and restart function: It can continuously monitor the system status of its own. When there is a problem with the SIM card or the module is not working properly, it will automatically restart the system.
9. Permanent +V Output Facility This output is available and ground on the main board. The output voltage is according to power supply and it can be used to power on other facility or device.
10 Input alarm message can be edited and programmed up to 50 characters long. You can use this function to program any languages. You can change the displayed text by sending a commands by sms to the unit.
11.Wireless Listening Device The WT-1010 has a built-in microphone that can be used for security and surveillance purposes. With this feature, it allows the user to observe the surrounding or the area of the unit.
12.Low power consumption - uses 30mA while in idle state and 260mA when transmitting an alarm
13.Wall mounting enclosure available: The WT-1010 units can be installed inside the alarm panel or inside its own wall mount enclosure.
14. Standby recharger battery to prevent power failure or electricity cut off by intruded. The GSM will function as normal when no electricity supply. LCD display to check the gsm signal strange and battery capacity.
13.Wall mounting enclosure available:The WT-1010 units can be installed inside the alarm panel or inside its own wall mount enclosure.
|
|
